Advertisement
Quick Links
Advertisement
Summary of Contents for ochain Active Spider
- Page 1 OCHAIN active spider user manual: installation, setup and maintenance.
-
Page 2: Limited Warranty And Disclaimer
If Ochain srl, after checking the product, finds that the damage is due to one of the reasons mentioned above, the warranty request will not be accepted and the defective item is sent back to the plaintiff who supports the shipping fees. -
Page 3: Maintenance
Inspect your OCHAIN product for wear, looseness or damage including cracks, dents and serious scratches before each ride and after every fall or crash. Do not use your OCHAIN product until it has been thoroughly inspected, repaired or replaced. PERIODICALLY CHECK THE TIGHTENINGS. INCORRECT TIGHTENING MAY... - Page 4 Compatibility: OCHAIN is a 1X 104 BCD** Boost active spider It replaces the stock chainring spider or direct mount chainring so that you can run your chainring on SRAM, RaceFace, Ethirteen and INGRID cranks direct mount...
- Page 5 **Bolt Circle Diameter or BCD is the imaginary cirlce that passes through the center of all the chainring mounting holes.
- Page 6 NOTE: If your bike already mounts a BCD 104 standard chainring bolted to the spider and you want to use it on OCHAIN, remove the chainring from the spider. For safety and performance reasons, make sure to check good conditions of chainring with the help of a professional bicycle mechanic.
- Page 7 Align OCHAIN with your crank arm as shown in the picture. Lasered mark signs “>>>” on OCHAIN surface show the correct crank arm position. Finally re-assemble your crankset referring to the manufacturer’s manual or to a professional bicycle mechanic.
- Page 8 OCHAIN. Clean OCHAIN perfectly from dust and mud with a clean cloth. NOTE: Please do not use any chemical products to preserve our environment. On a clean working flat and stable surface, place OCHAIN as shown in the picture.
- Page 9 Carefully lift only the upper element of OCHAIN so that small parts, elastomers ad springs will not loose their positioning. NOTE: use one finger to hold and maintain the bottom part of OCHAIN laid on a flat stable surface. Whenever everything goes wrong and you find yourself with pieces around, follow dedicated instructions video onOCHAIN Youtube channel.
- Page 10 Use Loctite medium on bolts. Tighten all four m4x8 mm bolts using a 2,5 mm hex wrench. Align OCHAIN with your crank arm. Lasered mark signs “>>>” on OCHAIN surface show the correct crank arm positioning. Finally re-assemble your crank referring to the manufacturer’s manual or to a professional bicycle mechanic.