Advertisement
7. Preparation installation and connection
4
Remove cap for entrance to inside housing for
connection of electrical wires. plugs and
grounding are already connected. Connect wires
to push wire connectors and refit plug with care.
8. Alternative connection on back side
Raepsaet product design bvba - since 1989 - nacebel 71121 - RSZ 000/1699918 20 - PC 209.069
Schaapschuur 4 / 1
TEL: +32 (0) 53/66.00.49
RPR Brussel – BTW-VAT: BE 0438.468.506
------------------------------------------------------ www.raepsaet.be ------------------------------------------------------
Remove covercaps to reach mounting holes
In case of standard connection (bottom), remove gland screw
cap and replace by cable gland M20, insert cable and connect
(only if charger is mounted in covered space).
Drill hole of 21 mm in center of plug and place included
cable gland M20. Continue as in standard connection
B-1790 AFFLIGEM
FAX: +32 (0) 53/66.00.46
BIC:KREDBEBB
(since 2017 cable gland is mounted standard)
MAIL:
post@raepsaet.be
IBAN BE48 7350 4245 1127
BELGIUM
Advertisement
