Network Id; Rts Key Time - Controlotron 1010PVN Field Manual

Section 4
after each carriage return that it transmits. This may be necessary to avoid the constant "wrap-
ping" of transmitted data onto a single line. The factory setting is [NO] (line feed disabled).
Note that the 996P portable printer requires [NO].
To enable (or disable) Line Feed:
To access the [Line Feed] option list press
Use
disabled.
To store the data press

4.8.5 NETWORK ID

The [Network ID] menu cell stores an identification number to facilitate host computer poll-
ing when you use this system in a network environment. The Network ID number can be any
value other than 0 (zero). The default setting, zero, disables the network function. Note that
entering a non-zero Network ID number suspends all routine Datalogger activity regardless
of any selected options.
NOTE: If you are using the flowmeter for a "stand-alone" application, you must keep
the zero Network ID number.
To assign a Network ID number
To enable numeric entry
Use the numeric keys to type the Network ID number.
To store Network ID

4.8.6 RTS KEY TIME

During a serial transmission session, you can select how long the flow computer holds its
request-to-send line high until it receives a clear-to-send signal. If the RTS key time expires,
the 1010 will return its RTS line low and abort the transmission attempt. Data entry units are
seconds. The default RTS key time is 0.2 seconds.
NOTE: The RTS Key Time function is only provided when the meter's network ID
number is non-zero.
To set the RTS Key Time:
To access the RTS Key Time option list press
To move the asterisk to the required RTS time press
To store the data press
to move the asterisk to [Yes] Line feed enabled, or [No] Line feed
. This moves the cursor to [Network ID].
ENT
.
ENT
. This moves the cursor to RTS Key Time.
ENT
4-15
1010PVNFM-3A