NOVABO SQUEALER-GSM Manual

To avoid problems in operating the unit, it is recommended to read this manual
thoroughly before using it. Do not interfere with construction or carry out
repairs yourself. Maintenance or repair work should be carried out by qualified
personnel (installer or company service). The manufacturer assumes no
responsibility for any damage resulting from improper assembly, malfunction
(device, software) or damage to the controller.
Description
SQUEALER controller is a modern microprocessor device for continuous monitoring
of the status of selected probes (MAX, OILER, SLUDO). The basic parameters of the
controller are 3 inputs, 3 relay output, LEDs indicating normal state, failure status and
alarm status, buzzer generating an alarm signal, alarm output, relay output, activated
at the time of alarm.
Front panel description
- LED lights continuously when the
power of the device is ON.
- the number of the LED flashes
indicates the GSM signal strength
(max. 4 flashes).
SQUEALER-GSM
The alarm module, powered by
- 3 inputs 230V, is used to measure and
- 3 output control the level of the sludge
- PS 230V layer, oil substances, grease,
- battery input petroleum
overflow of the tank.
connected and
properly set. Blinking LED indicates an
alarm sensor.
- The alarm is shown by the steady
light of the red LED + acoustic signal.
- A short press [<1] s button - delete
the buzzer alarm. Long press button
[> 2s]- clearing the alarm and restore the
relay to the state without an alarm.
- Checking the optical and acoustic
signals and relay outputs. Test can be
activated only when there is no alarm
sensors. Each time you press the button
activates / deactivates the function test.
– manual
substances and
- LED lights when the
probe detects ALARM
- LED is ON constantly,
when the sensors are
the dipswitches are