Quick Start Guide - CheckMK rack1 Mark III Quick Start Manual

Check_MK rack1 Mark III - Quick start

1. Quick start guide

• Unpack the device and first of all check that your shipment is complete.
• Plug in the device. When installing for the first time, you should ensure the following connections as
a minimum:
– Monitor-to-VGA connector
– USB-keyboard
– Network connection (connector: LAN1)
– Power supply
• During the launching procedure of the device, a dialogue box asking you to initialise the RAID will
appear on the screen (NOTE: All data on the hard drives will be deleted!). Confirm the box. After
a few minutes the launching procedure will resume.
• On completion of the launching procedure, the console status view will be displayed.
• So that the appliance can be used for monitoring, there are some settings that need to be made. Press
the key <F1> and, using the configuration dialogue box, configure the following settings as a minimum:
– Network configuration
– Access to the web interface
• Once you have configured these settings, you can access the web interface from a computer connected
to the network by entering the URL http://<ipaddress>/ into the web browser. Log into the web
interface using the password you just configured.
• Select the item instance administration
the following page.
• Now create a new monitoring instance using the current dialogue box. This instance will start auto-
matically.
• You can now call up the URL http://<ipaddress>/<instanz-id>/ in your browser,
where you can set up Check_MK in the usual manner.
• In order to make things such as name resolution and sending emails possible, you must make further
settings in the web interface. You can read more about this in the chapter on
the web interface.
The full manual can be found on
1
https://mathias-kettner.de/
©Copyright Mathias Kettner GmbH 2020
on the menu now shown and click on Create new instance on
1
our website .
1 / 3
basic configuration on
mathias-kettner.de