Motolux RF Programming Instructions

35mm RF TUBULAR MECHANICAL LIMIT MOTOR - 802132000 (MT35R-6-28-240/50)
The Motolux RF motor goes back to basics, with only simple PAIRING required between the motor and remote control. Limit
setting is via allen key. (see page 2 for details).
To Pair the Motor with a Remote/Channel
Note: This procedure only works on a motor that is not already paired to a remote control or channel.
1. Power must be turned off to the motor.
2. Press the UP (top) button for more than 3 seconds on the remote control to go into pairing mode and continue to hold the
UP button.
3. While still holding the UP button, turn the power to the motor on. The motor will jog, then jog again, you may release
the up button now.
4. Select the channel required on the remote (no channel selection is required on single channel remote) and press
briefly the UP (top) button. The motor will jog when the remote is paired.
To Change the Rotation Direction
1. Press and hold the STOP (middle) button of the programmed remote/channel for 7 seconds. The motor will jog.
2. Press briefly the DOWN (bottom) button within 10 seconds. The motor will jog.
To Return to Factory Mode
1. Press and hold the STOP (middle) button for more than 3 seconds to set the motor in programming mode. The motor will jog
once in programming mode.
2. Within 30 seconds, using a paperclip or similar, press and hold the programming button found on the back of the remote
control for more than 3 seconds. (The motor will jog, then jog again.)
To Add a New Remote or Channel
1. Using a remote or channel ALREADY PROGRAMMED to the motor, press and hold the STOP (middle) button for more than
3 seconds to set the motor in programming mode. The motor will jog.
2. Press briefly the UP button on the NEW remote/channel within 10 seconds. The motor will jog when the new remote or
channel is paired.
To Delete a Remote or Channel
1. On the remote or channel to be deleted, press and hold the STOP (middle) button more than 3 seconds to set the motor in
programming mode. The motor will jog once in programming mode.
2. Using a paperclip or similar, within 10 seconds, press the programming button on the back of the remote control for three
seconds. The motor jog when the remote or channel is deleted.
Motolux is a world-class manufacturer of motorisation products and systems dedicated to window covering markets
worldwide. A designer and manufacturer of a fully integrated range of motorisation solutions, Motolux products are
suitable for commercial or residential use. Our high quality product range is streamlined to simplify the process of
manufacturing, installation and ongoing maintenance of almost any type of motorised window covering product.
REVISION 2 - 2020
PROGRAMMING INSTRUCTIONS 1/3
Australian owned
Australian designed
Ordering Information
Australia / New Zealand
61 (0)3 9876 0400
sales@motolux.com.au
www.motolux.com.au