Motolux 592130000 Programming Instructions

Curtain Motor 1.5Nm 240V AC Hybrid Power - 592130000 (MR68-1.5/100-EM-P)
On the bottom of the motor you will notice a small hole
on the opposite side to the power cord, the programming
button is found inside this hole.
The default setting on these motors is a 3 Wire RF mode. If
the motors are being connected to an Automation System
and being switched by relays, they will need to be changed
to a 4 Wire mode.
Please follow the steps below after pairing a remote control.

Changing from 3 Wire To 4 Wire Mode

1. Connect the following wires to a 3 wire test lead: Brown (Active), Blue (Neutral) and Green/Yellow (Earth). If you are
using a test lead that accommodates both 3 and 4 wire, set it to the RF or RTS setting.
2. Power up the motor and pair the remote control by following the steps below.
Once the Remote has been paired:
To change from 3 Wire to 4 Wire – Press and hold the UP and STOP Buttons at the same time for approximately 5 seconds,
the light on the bottom of the motor will flash RED three times indicating the change from 3 Wire Mode to 4 Wire Mode.

Changing from 4 Wire Mode back to 3 Wire Mode

Once the Remote has been paired:
To change from 4 Wire back to 3 Wire – Press and hold the UP and STOP Buttons at the same time for approximately 5 seconds,
the light on the bottom of the motor will flash BLUE three times indicating the change from 4 Wire Mode to 3 Wire Mode.

Simple Programming

1. Pairing the motor to the remote: Start by selecting the Channel that you want to pair the motor with on the remote control.
Next
2. On the bottom of the Motor using a paperclip or a small screwdriver push and hold the programming button for
approximately 1 second and the light on the motor will slowly flash Red.
3. Now on the Remote Control push the UP button. The light will change from flashing RED to 3 BLUE flashes, indicating
that pairing was successful.

Changing Motor Direction

The UP button should be used to open the curtain and the DOWN button should be used to close the curtain.
1. Check the Direction: If the direction is correct there is no action required; move to Limit Setting.
2. If the direction is wrong, push and hold the STOP button for approximately 5 seconds until the light starts flashing RED
slowly. Within 10 seconds push the STOP button again. The light will change from flashing RED to 3 BLUE flashes,
indicating that the change of direction was successful. Test the curtain and the direction should now be correct.
Motolux is a world-class manufacturer of motorisation products and systems dedicated to window covering markets
worldwide. A designer and manufacturer of a fully integrated range of motorisation solutions, Motolux products are
suitable for commercial or residential use. Our high quality product range is streamlined to simplify the process of
manufacturing, installation and ongoing maintenance of almost any type of motorised window covering product.
REVISION 2 - 2020
PROGRAMMING INSTRUCTIONS 1/3
Australian owned
Australian designed
Ordering Information
Australia / New Zealand
61 (0)3 9876 0400
sales@motolux.com.au
www.motolux.com.au