Step-by-Step Build Guide (cont'd)
Step 6. Final Assembly
Tools and Materials Needed:
- Medium Bodied CA/Super Glue
- Accelerator for CA
- Needle Nose Pliers
Hardware Needed (links to recommended hardware on pg 4):
- 1mm O.D. x 240mm Long Carbon Fiber Rod for Wing Struts (x4)
- 1mm O.D. x 230mm Long for Elevator Hinge
- 1mm O.D. x 100mm Long for Rudder Hinge
- 0.8mm - 1.2mm steel wire for servo control rods
Step 6.1 Install Landing Gear
6.1.1 You will see two sets of slots in the bottom of the fuselage for the Main
Landing Gear assembly. The forward slots are for the taildragger
configuration and the rear slots are for the tricycle gear configuration.
Glue the Main Landing Gear Assembly in your preferred location using
CA glue and accelerator.
Nose Gear Slot
3D
Aeroventures
Tricycle Position
Taildragger Position
www.3daeroventures.com
w�w�3�A�r�v�n�u�e�.�o�
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
- 2� -