However you may have the skill set to complete the installation on your own. J Collection has no control over the installation, so you are responsible and liable for completing the installation correctly and safely.
• Carpenter glue. 3. INSTALLATION PROCESS UNDERSTANDING OUR CABINET CODES - EXAMPLES: CODE DESCRIPTION W1830 Wall cabinet 18" wide and 30" high WA2440 Wall angle corner cabinet 24" wide and 40" high Base cabinet, 30" wide and 34 1/2" high T302484.5...
Page 4
All dimensions are taken with the finished floor installed It is common that the finished floors are not perfectly level and for that reason all J Collection cabinets come with legs that are adjustable, making the installation easy and simple to level.
Page 5
Draw a level line at 34 1/2" from the highest 3) Use a stud finder to mark all the studs point of your floor and another level line at that will be used to install your cabinets. 54 1/2" from the same point. Install the top of the base cabinets level with the 34 1/2"...
Page 6
7) Set the next cabinet tight to the first 8) Always start with the corner base cabinet cabinet and use clamps to hold in place making sure it is level. Install 2 1/2" screws while you level it and make sure that through the top fastening strip into the the front edges are flush.
Filler For designs without a corner cabinet, Set the next cabinet tight to the first start with the first cabinet leaving space cabinet and use clamps to hold it place for a filler, as per your plan. while you level it and make sure that the front edges are flush.
Page 8
SINK/COOKTOP INSTALLATION When installing a sink or cooktop, trimming the top support rails may be necessary. Using the template supplied by the sink or cooktop manufacturer, cut the top rails as required using a jigsaw. BASE AND BASE BLIND CORNER CABINETS BBC (base blind corner) cabinets may be pulled out from the corner if required and the room is available.
Base Corner Cabinet (BC36LS) - Base corner cabinets are placed squarely in the corner, leveled and adjusted as required. They are held in place by cabinets on either side. Counter-sink screws on BC36LS door handles. Dishwasher Gables - Measure 24 1/8" over from the cabinet at the front and the back and draw a line on the floor.