Advertisement
transfusio-therm
The Quick Reference Guide must be kept directly on the transfusio-therm
clearly visible manner. Be certain to observe the following sequence of operations and
suggestions when putting the transfusio-therm
I.
Overview
Operator-Prompting Display
Status Line
User Interface for Compartment No. 1
User Interface for Compartment No. 2
User Interface for Compartment No. 3
®
2000
Quick Reference Guide
®
2000 into operation and when using it.
Confirmation Buttons with LED
Compartment No. 1
Compartment No. 2
Compartment No. 3
®
2000 in a
Start Button
with LED
LED
Alarm Signal
Compartment No. 1
Compartment No. 2
Nameplate
Compartment No. 3
ON / OFF Power Switch
Status: June 2013
Page 1 of 5
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for EIC transfusio-therm 2000
- Page 1 ® transfusio-therm 2000 Quick Reference Guide ® The Quick Reference Guide must be kept directly on the transfusio-therm 2000 in a clearly visible manner. Be certain to observe the following sequence of operations and ® suggestions when putting the transfusio-therm 2000 into operation and when using it.
- Page 2 ® transfusio-therm 2000 Quick Reference Guide Start-up and Operation Item Step Activity Display Important: Be Sure to Pay Attention to the Comments Below. Switching the Use the ON / OFF power switch to SELF-TEST; ON Appliance carries out a self-test switch the appliance on.
- Page 3 ® transfusio-therm 2000 Quick Reference Guide Target temperature Automatic acoustic signal and green The set target temperature will be flashing LED on the compartment reached x °C / CONFIRM displayed. concerned DEFROSTED / CONFIRM Confirming the Press the confirmation button of the compartment concerned.
- Page 4 ® transfusio-therm 2000 Quick Reference Guide them if they are found to be warmer than 41° C or show any visible signs of external damage. Clean the appliance whenever any bag leakage has occurred. Use the ON / OFF power switch to turn the appliance on again.
- Page 5 EIC Ltd. EIC Umwelt- und Medizintechnik Ltd., Rudolf-Diesel-Strasse 5, D-37308 Heilbad Heiligenstadt, Germany Telephone: +49 3606 607925, Fax: +49 3606 5071353, E-mail: eic-ltd.mail@t-online.de...
- Page 6 Meaning of the failure codes safety shutdown „transfusio-therm 2000“ controller version 7 and 8 Code Error Door switch, different signals Equipment protective cut-off Error turning / blocked or protective Equipment protective cut-off cut-off 2nd system Error turning / over-wound Equipment protective cut-off...
Need help?
Do you have a question about the transfusio-therm 2000 and is the answer not in the manual?
Questions and answers