Advertisement
A B A B A B H M L
J1
J2
P1
P2
J4
J3
J5
INTERNAL JUMPERS
Remove CellSet's top cover. Locate the 4 red thumb pull jumpers on the top of PCB (see figure, above).
If you are connecting the CellSet directly to the bike's auxiliary audio input via a KTG harness, set three of the
red jumpers in the "A" position.
If you are connecting the CellSet to the bike's auxiliary audio input via a KTG Audio Switcher, set three of the
red jumpers in the "B" position.
The fourth red jumper selects the audio level of the device when it is switched to the bike's intercom.
Turn on your Intercom and Auxiliary Audio system and adjust both to their usual settings. Put on your
helmet/helmet.
Switch the GPS device's audio between the bike's auxiliary and intercom system. Place the fourth red jumper
in the "L", "M", or "H" position as required for a uniform audio level.
Replace CellSet's top cover, and mount it in a sheltered location using the tie wraps provided.
Advertisement
