Page 1
SGY-120 Fully Pneumatic Piston Filling Machine SGY Series (Liquid Only) Operation Manual (Please read it carefully before using the machine!) ATTENTION: Machine must be completely torn down, cleaned, sanitized, and lubricated with H3 food grade lubricant prior to use. A recommended lubricant has been provided.
Instruction of Fully Pneumatic Filling Machine of SGY Series Table of Contents Chapter 1 Overview ......................3 1-1 Overview ........................... 3 1-2 Features ............................ 3 1-3 Parameters ..........................3 1-4 Working Principle ........................3 1-5 Working Process ........................4 1-6 Available Range ......................... 4 Chapter 2 Operation Instruction ....................
Chapter 1 Overview 1-1 Overview The SGY series fully pneumatic filling machines are newly designed for liquid, paste, and cream filling, and its filling amount can be adjusted as required based on the specified range, featuring high stability, reliability and filling accuracy.
Instruction of Fully Pneumatic Filling Machine of SGY Series 1-5 Working Process Open the inlet valve, adjust the working air pressure and select the working status (automatic or semiautomatic). During the operation, the rotary cylinder linkage is turned (opens a path towards the front while sealing towards the top), the fill head cylinder moves upwards to open the discharge valve, the piston cylinder actuates to move the piston forward, which dispenses material for filling ( the speed can be adjusted by the “Behind”...
Page 5
Instruction of Fully Pneumatic Filli ng Machine of SGY Series 1-7 Introduction to Parts and Specifications 1. Fill head air cylinder 11. Air regulator 2. Fill head reducer nozzle 12. Protective covering 3. Stainless T joint 13. Rotating hand wheel 4.
Instruction of Fully Pneumatic Filling Machine of SGY Series Chapter 2 Operation Instruction 2-1 Preparation 1. Precautions The inlet air pressure should be 0.5-0.8Mpa and the working air pressure should be 0.4-0.5 Mpa. Keep all appendages clear of moving parts during operation.
Instruction of Fully Pneumatic Filli ng Machine of SGY Series 2-2 Operation Method Connect the air source and slide the air inlet collar toward the machine. Check whether the air pressure meter is in the specified range (roughly reading in the “12-3 o’clock” range). If not, draw the air pressure knob outwards to unlock, rotate the pressure regulator until the pressure is in the specified range (0.40.5Mpa) and push the knob back in to lock.
Instruction of Fully Pneumatic Filling Machine of SGY Series 2-3 Fault Analysis and Troubleshooting Symptom Analysis Troubleshooting Check whether the air pressure collar is open Open it Check whether the air source is open Open it (compressor) Check whether the value on air pressure meter is Adjust it to 0.4-0.5MPa...
Instruction of Fully Pneumatic Filli ng Machine of SGY Series 2-4 Safety Instruction You can use soap and warm water to clean the machine. Fill hopper with cleaning agent and water; cycle until discharge is clear of any product; fill hopper with clean water and cycle until water is clear.
Instruction of Fully Pneumatic Filling Machine of SGY Series Chapter 3 Machine Specification 3-1– SGY-120 O Seal ring Listing Single Head size/american standard Type Size/metric Material Quty Φ16mm*Φ4mm O Seal ring DASH 208 nitrile rubber 2pcs φ12mm*Φ3mm O Seal ring...