DynaNav Installation Manual Overview of System The DynaFlight-AirAgII™ system is a GPS based electronic guidance and data management system specifically designed as a tool for the pilot to fly parallel swath guidance for the application of seeds, fertilizer and chemicals for farm and forestry applications.
Keep away from other communications antennas as far as possible. Do not mount immediately next to gear struts of hook assembly The shorter the coax the better the range. 121 – 18799 AIRPORT WAY, PITT MEADOWS, BC, CANADA, V3Y 2B4 PHONE: 604-465-0009 WEB PAGE: www.dynanav.com EMAIL: airag@dynanav.com FAX: 604-465-0084...
Processor box Overview The DynaFlight-AirAgII processor box contains all the electronics of the system. It has a mounting plate that is bolted to the rubber shock mount on the bottom (see:- Mounting Plate in appendix). This plate only requires 4 mounting screws to attach therefore the extra tabs for mounting can be removed if necessary.
The connector plug is a LEMO connector that is simply pushed on (align red dots first) and simply pulled off to remove. 121 – 18799 AIRPORT WAY, PITT MEADOWS, BC, CANADA, V3Y 2B4 PHONE: 604-465-0009 WEB PAGE: www.dynanav.com EMAIL: airag@dynanav.com FAX: 604-465-0084...
The supplied ErgoGrip™ is to replace the existing control grip on the flight control stick. 121 – 18799 AIRPORT WAY, PITT MEADOWS, BC, CANADA, V3Y 2B4 PHONE: 604-465-0009 WEB PAGE: www.dynanav.com EMAIL: airag@dynanav.com FAX: 604-465-0084...
With the grip or collective switch box in the pilots hands, the pilot will be able to change job functions while observing the display to keep his field of view outside the helicopter/aircraft, not inside the cockpit. 121 – 18799 AIRPORT WAY, PITT MEADOWS, BC, CANADA, V3Y 2B4 PHONE: 604-465-0009 WEB PAGE: www.dynanav.com EMAIL: airag@dynanav.com FAX: 604-465-0084...
Dual Relay box Overview The dual relay box has multiple functions to interface the aircraft and the pilot to the DynaNav system. These functions are as follows: NOTE: THIS BOX MUST BE INSTALLED IN ALL INSTALLATIONS TO PROTECT THE COMPUTER.
Includes WAAS/EGNOS Real Time differential correction (RTCM 104 specification) to sub-meter accuracy. • DynaNav basic ErgOS™ operating system with DynaFlight-AirAg version 2.0 software template. • DynaViz™ Display Unit EL flat panel display showing position, moving-map, guidance and operating buttons, for a safe operation.
Page 18
LOW LEVEL OUT 1 2. IF DESIGNATED FUSE/CIRCUIT BREAKER LOCATION IS USED BY OTHER INSTALLATION, LOCATE 5 AMP LOW LEVEL OUT 2 FUSE/CIRCUIT BREAKER IN CONVENIENT UNUSED LOCATION IN FUSE PANEL. LABEL FUSE "DYNANAV". Pitt Meadows LOW LEVEL OUT 3 BC Canada 3.
Need help?
Do you have a question about the DynaFlight-AirAgII and is the answer not in the manual?
Questions and answers