Related Manuals for MAXXCELL 24-200MAX
Summary of Contents for MAXXCELL 24-200MAX
- Page 1 USER GUIDE LiFePO4 Battery System for Households LiFePO4 Battery System for Households www.maxxcell.com.au 358-010029-00...
-
Page 2: About This Manual
BMS failsafe has activated you must charge the battery immediately. If you do not you may need to use the AC or PV activation method to wake the battery. Doing so will reduce the lifespan of your pack www.maxxcell.com.au... -
Page 3: Specifications
LiFePO4 Battery System for Households 2. INTRODUCTION 2.3 Specifications Purpose built solar and wind energy storage battery pack. Designed for simple 2 wire installation without the Model 24-200MAX 48-200MAX complexity of Inverter and battery BMS compatibility. Usable Capacity 5.12KWH 10.24KWH Voltage 2.1 Features... -
Page 4: Installation
• The recommended installation position is to be mounted to the wall vertically. • Be sure to keep other objects and surfaces as shown in the right diagram to guarantee sufficient heat dissipation and to have enough space for removing wires. 24-200MAX 24-250MAX Step 3: The communication terminal (the other Step 4: After all connections have been made, as end) is connected as shown in Figure 3. -
Page 5: Operation
For pure off grid system, the PV awake wire needs to be connected with MPPT charge controller if the battery DIP SWITCH pack is charged by solar panels only. The connection diagram as below : Communication Address MaxxCell Inverters Only Termination Resister 4.2 Description for LED The SOC of the battery is shown by the LED 100% Flashing SOC<10%... -
Page 6: Emergency Situations
Remark 1: In SOC indicator, LED1 is green and red light Remark 2: Flash 1=0.2s on/0.2s off; Flash 2=0.5s on/0.5s off; Flash 3=1.5s on/1.5s off; Flash 5=4.0s on/4.0s off Remark 3: Low power refers to SOC below 10% (default) or in charging mode www.maxxcell.com.au...
Need help?
Do you have a question about the 24-200MAX and is the answer not in the manual?
Questions and answers