TRAXION STRUXURE DESIGN 5-306 Instructions

TRAXION STRUXURE DESIGN 5-306 Instructions

Three-section compact-fold loading ramp

Advertisement

Three-Section Compact-Fold Loading Ramp
LIGHT AS ALUMINUM
READ, UNDERSTAND, FOLLOW AND SAVE THESE INSTRUCTIONS
If you are unsure of safe usage or have any questions phone us at 479-474-3460.
Read and understand all instructions before use.
Use caution when loading and unloading equipment.
Do not exceed rated capacity of 600 lbs per ramp.
Do not exceed maximum height of 34 inches or 86 centimeters.
Use only on firm and level ground.
Center tire path between side rails of the ramp(s).
Ramp surface must be dry, clean and free from oil or grease.
If loading or unloading from a vehicle, be sure the vehicle is PARKED with emer-
gency/parking brake ON and the engine turned OFF.
Danger of serious personal injury exists anytime you use a loading ramp.
NEVER ride an ATV or any other motorized equipment up or down a loading ramp.
ALWAYS attach safety strap(s). Make sure the strap is properly adjusted for length to
prevent kick-back of the loading ramp.
Ensure the safety strap does not allow rear-ward movement of the loading ramp.
Align individual ramps to correctly correspond to your vehicle's track.
If a ramp is bowing while loading, remove load immediately.
Keep body parts and all clothing clear of pinch points.
Do not exceed maximum height of 34 inches or 86 centimeters.
ALWAYS ATTACH SAFETY STRAP
SAFETY STRAP MUST BE ATTACHED AND PROPERLY
ADJUSTED TO PREVENT RAMP FROM SLIPPING OFF OF
www.traxionproducts.com
phone: 479-474-3460
STRONG AS STEEL
CAUTION
!
WARNING
!
DANGER
!
THE LOADING SURFACE.
THIS IS A PATENTED PRODUCT
Model 5-306
!
!
!

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STRUXURE DESIGN 5-306 and is the answer not in the manual?

Questions and answers

Summary of Contents for TRAXION STRUXURE DESIGN 5-306

  • Page 1 Three-Section Compact-Fold Loading Ramp Model 5-306 LIGHT AS ALUMINUM STRONG AS STEEL READ, UNDERSTAND, FOLLOW AND SAVE THESE INSTRUCTIONS If you are unsure of safe usage or have any questions phone us at 479-474-3460. CAUTION Read and understand all instructions before use. Use caution when loading and unloading equipment.
  • Page 2 INSTRUCTIONS FOR SAFE USE OF THE LOAD-TRAX RAMP 1. Attach the strap to the ramp by wrapping the strap around the cross tread closest to the ramp ngers. Then loop the S-hook and strap through the end loop as shown here. SAFETY TIE-DOWN STRAP Working load limit: 400 lbs or 180 kg Break strength: 1200 lbs or 540 kg...

Table of Contents