Okotech heatboss thermostat Installaton Manual

Thermostat Installaton Guide
01
Introduction
heatboss thermostat is an intelligent wireless temperature,
®
humidity and movement sensor. It is installed in a room to
monitor and control the heating along with heatboss
wireless valve.
02
Pre-install
• Determine if the heatboss ® thermostat is going to be
powered from the mains power supply, if so, the
thermostat P ower Module will need to be installed. The
m odule will be installed inside a single gang wall socket.
• S crew/stick the white back plate
o nto an internal wall. Ensu re that it is
m ounted level with the arrow pointing
upwards and away from heat sources.
e .g. radiators, electric heaters, direct
sunlight, doors, draughts etc.
• Ensure thermostat has good air
c irculation and mounted 1.4m from
the ground.
03
Install
• Log on to heatboss® user interface.
• Select Zone, Rooms & Controllers
from the dropdown menu.
• Select the desired room you want to
install the thermostat to and click "add
device"
• Pull out battery tab on thermostat and
mount onto back plate, then attach
both screws.
• The thermostat will scan for the hub,
this takes up to 30 s econds, whilst
this is happening the stat will
display the symbol to the right.
• After around 30 seconds the stat will display...
®
• The thermostat is now successfully installed.
04
Customise Schedules
• On the heatboss ®
times and temperatures for the room the thermostat is
1.4 m
linked to.
• S imply click the
• These schedules will be sent wirelessly to the thermostat within
10 minutes (at the very most).
then
user interface you c an now set on/off
icon and create schedules.
05
Display Symbols
S canning for hub S ynchronised to hub/
operation sucessf ul
Reset in operation Bat tery low / battery
mode selected
Main mode selected S et-up c omplete
S tat disabled - No C hild lock - Stat input
schedule will be is locked out and can
run. R e-enable from only be unlokce d from
user interface user interface
Network loss
All LEDs flashing
Factory reset performed
Yellow flashes once per minute
Bat tery low
Green illuminated when
setting target temperature
Within Eco range i.e. 17 - 19°C
Yellow illuminated when
setting target temperature
Within 19 - 22°C
Red illuminated when
setting target temperature
High i.e. 22°C +