WaterAce Pedestal Series Owner's Manual

WaterAce Pedestal Series Owner's Manual

Sump pumps

Advertisement

Owner's Manual
Pedestal Series
Sump Pumps
WA33PPED
with Vertical
Switch

TABLE OF CONTENTS

General Safety . . . . . . . . . . . . . . . . . . . . 2
Specifications. . . . . . . . . . . . . . . . . . . . . 3
Installation. . . . . . . . . . . . . . . . . . . . 4 & 5
Troubleshooting . . . . . . . . . . . . . . . . . . . 6
Warranty . . . . . . . . . . . . . . . . . . . . . . . . 7
WA50CPED
with Vertical
Switch

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Pedestal Series and is the answer not in the manual?

Questions and answers

Summary of Contents for WaterAce Pedestal Series

  • Page 1: Table Of Contents

    Owner’s Manual Pedestal Series Sump Pumps WA33PPED WA50CPED with Vertical with Vertical Switch Switch TABLE OF CONTENTS General Safety ....2 Specifications.
  • Page 2: General Safety

    STOP Before you start A sump pump is an electrical device designed to operate in inherently wet environments. ALWAYS USE EXTREME CAUTION when installing or maintaining this product! Need Help: Call 1-844-394-2604 for assistance; Do Not Return to Store GENERAL SAFETY Important Safety Instructions General Safety Carefully read and follow all safety...
  • Page 3: Specifications

    APPLICATIONS Ideal for High-Volume Water Removal from Basement Sump Pits SPECIFICATIONS & PERFORMANCE Capacity Cord Solids Model Volt Amps (GPH at 0’) Max Head Construction Impeller Length Pumped WA33PPD 3000 18’ Thermoplastic Thermoplastic 8’ 3/16” WA33CPED 3480 18’ Cast Iron Thermoplastic 8’...
  • Page 4: Installation

    INSTALLATION Do not work on pump until power is unplugged. (b) Cutting off the ground pin or using an adapter fitting. Do not cut off ground pin or use an adapter (c) Working on pump or switch while fitting. plugged in. Do not use an extension cord.
  • Page 5 INSTALLATION Discharge piping can be PVC, polypipe or galvanized steel. CAUTION: Check local codes before installing pump. STEP 1: Inlet Pipe Pump must be installed in a suitable gas tight, properly vented basin which is at least 24” deep and at least 14” wide for pumps fitted with vertical on/ off switches.
  • Page 6: Troubleshooting

    TROUBLESHOOTING CHECKLIST (Caution: shut off power to pump) POSSIBLE CAUSES/SOLUTIONS PROBLEMS • Line circuit breaker is off, or fuse is blown or loose PUMP DOES NOT RUN • Water level in sump has not reached turn-on level as indicated in AND MAKES HUMMING installation drawing.
  • Page 7: Warranty

    WARRANTY Retain Original Purchase Receipt for Warranty Eligibility Limited Warranty Manufacturer warrants to the original consumer purchaser (“Purchaser” or “You”) that its products are free from defects in material and workmanship for a period of twelve (12) months for plastic and twenty-four (24) months for cast iron from the date of the original consumer purchase.
  • Page 8 1899 Cottage Street Ashland, Ohio 44805 Telephone: 1-844-394-2604...

This manual is also suitable for:

Wa33ppedWa50cpedWa33ppdWa33cpedWa50ppd

Table of Contents