Maxcom KXT709 Manual page 8

know the secret code in order to dial through the line.
TRANSFER BETWEEN PARALLEL PHONES
 Setting paging number
1. In on-hook state, press and hold SET key, LCD displays EL--
2. Key in "*" and the paging number (example "*1" and "*2" ), use DEL key to edit
3. Press SET key to confirm and exit.
 Transferring the line from paralleled phones
When a call comes, use one of paralleled phones to answer. Press "*" and the paging number
that was set in another telephone unit, the unit rings, pick up its handset or press key to
answer the incoming call.
NOTE: Please use same series phones to transfer as above operation. Any special
*
services starting with " " offered by your Telephone company may not function properly.
To get the best effect of this function, you should load the batteries before using.
ANTI-DIALING FROM PARALLEL PHONES FUNCTION
1. In on-hook state, press and hold #/= key for 3 seconds, LCD displays SPI ON
2. Press key twice and then
3. Press and hold #/= key for 3 seconds again, LCD displays SPI OFF
When the anti-steal dialing is set to ON, users who want to dial using an extension via the same
line will hear a "DI-DI, DI-DI" beep continuously and will not be allowed to make a call.
SETTING RINGING TONE AND ADJUST RINGING VOLUME
There are 16 kinds of ringing tone and ringing OFF for selection:
1. In on-hook state, press RING key, LCD displays ring 02 db8
2. Press RING to select the desired ringing or set ring OFF.
3. Press UP/+ or DOWN/– key to set ringing volume.
4. Press SET to confirm and exit.
NOTE: The volume ranges from 1db-8db, with 8db being the loudest. Ring OFF is "Do Not
Disturb" mode. If the phone is set to this mode, the telephone will not ring when there is an
incoming call.
ADJUST HANDSFREE VOLUME
In hands free mode, press UP/+ or DOWN/– to adjust the handsfree volume, LCD displays the
volume level and there are a total of 4 levels.
SELECTING PULSE OR TONE DIALING MODE
1. In on-hook state, press and hold */. key for 3 seconds, LCD displays P, then dialing mode
is set as Pulse.
key twice and hold */. key for 3 seconds again, LCD displays T, then dialing
2. Press
8