Ferroli CONNECT Manual page 25

4) dhW temperatures (OpenTherm boilers only)
» Press the buttons
enter.
» Press the buttons
» Press "set"
Note: If the thermostat receives the data from the boiler, then it displays this value,
otherwise the setting range is 30 – 60°C.
5) Information from the boiler (OpenTherm boilers only)
» Press the buttons
» When " " is displayed, it means the data is not available in the boiler
» Press "set"
No. information
1 Set temperature
2 Flow probe
3 Return probe
4 DHW temperature
5 Outside temperature
6 Power percentage
7 DHW draw
8 System pressure
6) advanced settings (Pl)
» Installer parameters
7) Exit
» Press "set"
to select the DHW temperature, and then "set"
to change the value.
or "mode" to return to the previous menu.
to select information, and then "set" to enter.
or "mode"
to return to the previous menu.
4 digit on the display
th
1
2
3
4
5
6
7
8
to return to the main menu.
cod. 3541S180 - Rev. 04 - 09/2019
to
51
EN