Advertisement
Mop Mode (continued)
Manual Cleaning
1.
2.
Turn the robot ON.
Start the robot automatically
with the app, or manually by
pressing the play/pause button.
Sanitizing with Spot Mode
In Spot Mode, use BISSELL® Hard Floor Sanitize Formula to sanitize floors after tough messes like pet
accidents, or give areas extra attention with BISSELL® Multi-Surface or Natural Pet Formulas.
Note: You can sanitize three to four different areas around your home with a single tank.
1.
2.
Wipe up the mess with a
Add BISSELL Hard Floor
disposable towel.
Sanitize Formula.
x2
40 inches
40 inches
(1m)
(1m)
4.
5.
To start cleaning, press
The robot will clean in a
the play/pause button twice
square pattern covering an
or select "Spot" mode in the
area approximately 40" x 40"
BISSELL Connect App.
for about 5 minutes. It will
beep when finished and return
to the dock.
WARNING
To reduce the risk of fire due to internal component damage use only BISSELL cleaning products
intended for use with this appliance.
8 BISSELL.com
3.
When the robot is finished
cleaning, it will return to the
dock. If you want it to return
to the dock before cleaning is
complete, press the play/pause
button, then press home.
HARD FLOOR
SANITIZE
3.
Place the robot in the center
of the area you want to clean.
40 inches
40 inches
(1m)
(1m)
6.
Use caution when walking
through the area as the floor
may be slippery. Allow to
remain wet for 5 minutes.
Mop Mode (continued)
Maintaining the Mop Pads and Debris Trap
1.
2.
Turn the power switch OFF.
Firmly pull up on the mop
Press the button on top of the
pads to remove from mop pad
mop tank and pull to remove.
drivers. Replace mop pads if
Place tank upside down on a
damaged.
soft surface.
4.
5.
To reattach, use the middle
Empty the dirt bin after
hole on the pads to align with
each use, including after
the driver.
mopping.
7.
Lift up on the filter cover
located on top of the tank and
remove the filter. Brush off
dust and debris from the filter.
WARNING
To reduce the risk of fire, turn the power switch OFF before performing maintenance or
troubleshooting checks.
3.
Machine wash separately in
warm water.
6.
Push the tab on the top of
the mop tank to open the dirt
bin and empty it.
BISSELL.com 9
Advertisement
