Connecting The Scanner To The Macintosh Computer - AGFA SnapScan e20 Owner's Manual

Connecting the Scanner to the Macintosh
Computer
Caution: For your safety, use the adapter that comes with this product. Do not use any substitute.
Misuse of the power adapter can cause serious damage to the product and a safety hazard while
using it.
Note: Check if the AC Adapter complies with your local power supply.
Note: Make sure the scanner is unlocked (see
the electric outlet.
1 Connect the plug of the AC adapter to your scanner.
2 Connect one end of your USB cable to the USB port on your scanner. Make sure you connect
the correct plug as shown in the figure above.
3 Plug the adapter in the wall outlet.
4 Connect the other end of your USB cable to a USB port on your computer. Make sure you
connect it to the correct port as shown in the figure below. A USB port is labeled with the USB
icon .
Unlocking the Scanner) before connecting it to
Chapter 3: Installing the Scanner for Macintosh 24