HARDWARE USED 8× hand tighten the bolts HORIZONTAL RIM #90-208 Hex Bolt 5/16" × 1" #98-116 Flat Washer BRACKET HEAD #98-157 Spacers #94-116 Serrated Nut C5-BA13-4 Installation Guide | REV. A1 | Page 8 For technical support, contact us at 1-800-565-5321...
Page 9
Mark the 2 holes locating each end panel to the vehicle floor. NOTE: If you are using Ranger floor, please go to page TOOLS q Marker MARK C5-BA13-4 Installation Guide | REV. A1 | Page 9 For technical support, contact us at 1-800-565-5321...
Page 10
1/2" Drill Bit w/ Drill Collar ( Set at 1/2" ) q Plus Nut Tool ( 5/16" ) HARDWARE USED 12× #94-132 Plus Nut DRILL COLLAR 1/2" ) seT aT C5-BA13-4 Installation Guide | REV. A1 | Page 10 For technical support, contact us at 1-800-565-5321...
Page 11
1/2" socket until the plusnut locks, then remove the bolt by turning the impact in reverse. FORWARD REVERSE C5-BA13-4 Installation Guide | REV. A1 | Page 11 For technical support, contact us at 1-800-565-5321...
Page 12
( QTY = G ap beTween floor and end panel #94-132 5/16" Plusnut most vehicle use spacer when not over ribs W/ Spacer W/O Spacer C5-BA13-4 Installation Guide | REV. A1 | Page 12 For technical support, contact us at 1-800-565-5321...
Page 16
“You have successfully installed your C5-BA13-4 Thank you for doing business with us.” cs@rangerdesign.com For any feedback or suggestions you may have, please contact: C5-BA13-4 Installation Guide | REV. A1 | Page 16 For technical support, contact us at 1-800-565-5321...