Table of Contents
Advertisement
Displayed only when PRINTER TYPE is set to LOCAL. This softkey is for
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
PRINTER ADDR
changing the address of the printer (select code and HP-IB address).
After selecting this softkey, the message \Type new address" is displayed.
Enter the new printer address, then press
Displayed only when PRINTER TYPE is set to HP-UX SPOOL. This
NNNNNNNNNNNNNNNNNNNNNNN
COMMAND
softkey is for changing the HP-UX spooling command.
After selecting this softkey, the present spooling command is displayed at
the keyboard input line and the following message appears.
Enter the new spooling command. Note that the pipe
rst. For example:
Displayed only when PRINTER TYPE is set to FILE SPOOL. This
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SPOOL DIR.
softkey is for changing the spool directory of the SRM system.
After selecting this softkey, the following message appears, and the present
spooling command is displayed at the keyboard input line.
Enter the new spooling directory. For example,
For changing the page length of the printer (lines/page). The allowable
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
PAGE LENGTH
range is 10 through 32767.
B-4 Configuring the System Printer for PV4062/PV4062.F
If you press
only, the present address of the printer is retained.
4 Return 5
If you enter a new select code and HP-IB address, the message \Select
printer I/F" is displayed and two softkeys|
Select the required softkey.
If you enter a new select code only, the message \Select printer I/F" is
displayed and two softkeys|
If you select the
NNNNNNNNNNNNNNNNNNNNNNN
RS-232C
RS-232C I/F" is displayed. The following baud rates are available:
50, 75, 110, 134, 150, 200, 300, 600, 1800, 2400, 3200, 4800, 9600, 19200
Enter new spooling command with leading '|' in double quotations.
"| lp"
"| cat > file1"
"| remsh hpux lp -dlaser -oc -od"
Enter new spooling directory in double quotations.
.
4 Return 5
NNNNNNNNNNNNNNNNN
HP-IB
and
NNNNNNNNNNNNNNNNNNNNNNN
NNNNNNNNNNNNNNNNN
RS-232C
OTHER
softkey, the message \Enter baud rate of
"/spool:REMOTE"
and
|appear.
NNNNNNNNNNNNNNNNN
OTHER
|appear.
must be speci ed
|
.
Advertisement
Table of Contents
