Test Procedure; 4062F Dc W/O Dvm Test Startup Page - HP 4062UX Installation Manual

Test Procedure

1. Select the
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
4062F DC W/O DVM
After selecting the
minute.
When START nishes, a con guration page of START similar to that shown in Figure 6-3
is displayed for less than a second, then the start-up menu page as shown in Figure 6-29
appears on the screen.
If your HP 4062F system is equipped with an HP 4284A CMU84, the
softkey is also displayed. If you select this softkey, the CMU84 performs the OPEN and
SHORT correction. However, you do not need to execute this correction to verify HP
4062F system installation. Refer to the HP 4284A
Do not touch the measurement pins of the SWM or the contact pads of the
Caution
relay test adapter with bare hands. Oil, perspiration, and dirt prevent good
electrical contact and degrade measurement accuracy.
d
c
6-28 System Verification
softkey.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
4062F DC W/O DVM
********************************************************************************
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
HP 4062F Performance Verification Program for DC function
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
* Select the "Start" softkey to begin Performance Verification.
* Select the "Help" softkey to display the program operation guide.
Mount the 16066A atop the SWM and then select Start.
aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa
START Help
Figure 6-29. 4062F DC W/O DVM Test Startup Page
softkey, the START.F program runs for about one
Operation Manual
User 1
aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa
Reconfig
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
HP4284A Corr.
for details.
a
Caps Running
EXIT
b