JVC GR-D60EK Service Manual page 25

2.5.2 Disassembly of MONITOR ASSEMBLY (3.5 INCH)
NOTE:
Be careful in removing or handling the monitor assembly, es-
pecially not to soil or scratch the monitor screen during the dis-
assembly procedure.
(1) While removing the four screws (1 to 4) in numerical order
and then disengaging the four hooks (L10a-L10d) in alpha-
betical order, open and remove the MONITOR COVER
ASSEMBLY.
(2) Remove the SENSOR BOARD ASSEMBLY from the
MONITOR CASE.
(3) Disconnect the FPC in the connectors CN10a and CN10b
in this order, and then remove the MONI.HINGE ASSEM-
BLY.
(4) Disconnect the FPC of the LCD MODULE from the connec-
tor CN10c.
(5) Remove one screw (5) and then remove the BL BOARD
ASSEMBLY together with the BACK LIGHT.
NOTE 10:
Since the BACK LIGHT is soldered to the BL BOARD
ASSEMBLY, the BACK LIGHT should not be separated
from the BL BOARD ASSEMBLY except when replacing
them.
(6) While removing the five hooks (L10e-L10i) in alphabetical
order, remove the LCD FRAME together with the LCD
MODULE.
(7) Remove the SHIELD CASE.
1-14 (No.86733)
(S10a)
1
L10d
(S10a)
L10a
3
(S10b)
4
(S10b)
MONI.HINGE
ASSEMBLY
b
CN10b
5
(S10a)
SENSOR BOARD
ASSEMBLY
L10h
L10g
. .
:0.069N m (0.7kgf cm)
. .
:0.098N m (1.0kgf cm)
Fig.2-5-2
2
MONITOR COVER
ASSEMBLY
L10c
L10b
CN10a
BL-3.5 BOARD
ASSEMBLY
b
CN10c
a
NOTE10
BACK LIGHT
L10i
LCD FRAME
LCD MODULE
SHIELD CASE
L10e
L10f
a
MONITOR CASE