Assembling The Blower Tubes - Ryobi RB-264S Owner's Operating Manual

PACKING CONTENTS (FIG.1)
• Blower assembly.
• Upper blower tube.
• Lower blower tube.
• Screwdriver (1).
• Wrench for spark plug (1).
• Empty bottle.
• Operator's manual.
WARNING. To prevent an accidental
start that could cause serious personal
injury, always disconnect the engine
spark plug wire from the spark plug
when assembling parts.
WARNING. If any parts are damaged or
missing do not operate this product until
the parts are replaced. Use of the
product with damaged or missing parts
could result in possible serious personal
injury.
WARNING. Do not attempt to modify this
product or create accessories not
recommended for use with this product.
Any such alteration or modification is
misuse and could result in a hazardous
condition leading to possible serious
personal injury.
WARNING. This product is intended for
blower use only and is not designed for
vacuum use. Do not attempt to open the
air inlet cover that covers the impeller.
Opening the air inlet cover may result in
contact with the impeller blades and
cause serious personal injuries.

ASSEMBLING THE BLOWER TUBES

Align the raised tabs on the lower blower tube to
the slots on the upper blower tube, slide together
and tighten securely by twisting. Check the
tightness after initial use and retighten if needed.
To remove the tubes, rotate the upper blower tube
and remove from the lower blower tube.
Insert the upper blower tube to the engine air tube
(2) and lock the tube by turning 90 degree (1),
Fig.2.
The lower air tube should be connected to the
upper air tube in the same way.
ASSEMBLY
1
6
Fig. 1
2
Fig. 2