Emc Environmental Conditions For Products Installed In The European Union; Emc Class A Notices And Warnings; Class A Notice For Fcc; Class A Notice For Canada - Cisco Catalyst 2940 Regulatory Compliance And Safety Information Manual

Cisco systems hub/switch regulatory compliance and safety information

Hide thumbs Also See for Catalyst 2940:

Table of Contents

EMC Environmental Conditions for Products Installed in the European Union

EMC Environmental Conditions for Products Installed in the

European Union

This section applies to products to be installed in the European Union.

The equipment is intended to operate under the following environmental conditions with respect to

EMC:

•

In addition, if equipment is operated in a domestic environment, interference may occur.

This section includes the EMC Class A warnings for the Catalyst 2940 switch.

Modifying the equipment without Cisco's authorization may result in the equipment no longer

complying with FCC requirements for Class A digital devices. In that event, your right to use the

equipment may be limited by FCC regulations, and you may be required to correct any interference to

radio or television communications at your own expense.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference in which case users will be

required to correct the interference at their own expense.

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.

Regulatory Compliance and Safety Information for the Catalyst 2940 Switch

A separate defined location under user's control.

Earthing and bonding shall meet the requirements of ETS 300 253 or CCITT K27.

AC power distribution shall be one of the following types, where applicable: TN-S and TN-C as

defined in IEC 364-3.

78-16656-01

Table of Contents