Table of Contents
Advertisement
Operation Manual / TPR56-F + TPR61-F
7 Removal and installation / 7.3 Installing the turbocharger
7.3 Installing the turbocharger
Tightening torques for
fixing screw (01)
If provided:
© Copyright 2018 . All rights reserved.
Remove the cover from the oil connection.
u
There is an orifice in each of the two oil inlet channels of the bearing cas-
ing. The diameter of this orifice has been individually adapted by the en-
ginebuilder for the purpose of adjusting the oil pressure. When the tur-
bocharger is exchanged, always make sure that the orifice with the cor-
rect diameter is installed in the oil-feeding oil inlet channel.
Reuse the same orifice that was installed before.
u
TPR56-F
135 Nm
Inspect the lifting gear.
u
Attach one lifting gear each to the two fins of the bearing casing
u
provided for this purpose.
Align turbocharger on bracket.
u
Fit the sliding blocks (02).
u
Tighten the inner fixing screws (01) crosswise. Observe the tightening
u
torque.
Tighten the outer fixing screws (01) crosswise. Observe the tighten-
u
ing torque.
Plug in the cable connector (86515) onto the speed sensor.
u
Attach all gas, air, water and oil pipes in accordance with the engineb-
u
uilder's instructions.
HZTL2490_EN
TPR61-F
205 Nm
Revision D
May 2018
Advertisement
Table of Contents
