13.8. Quartz Heater
1. Remove the sensor cable from the DPC connector CN7.
2. Remove the exhaust guide A by removing the two screws shown
in figure 10.
3. Disconnect the cables to the grill heater
4. Remove the grill cover by removing the 5 screws in figure 11
5. Remove the two screws holding the grill heater (Figure12).
6. Loosen the 2 screws holding the ceramic grill holders, turn the
holders to release the grill element.
7. Remove the heater bracket D by using a flat blade screw driver to
lever back the tabs.
8. The grill element can now be removed from inside the oven.
Removing the Turntable motor cover
Figure 9
Two screws to remove the turntable motor
Figure 10
43