User Keyless Code - Mercury SmartCraft SC5000 Operation Manual

SYSTEM
System Calibration

User Keyless Code

A keyless code can be set to prevent unintentional power-up of the System View when using
the HOME (Power) button. Once a keyless code has been set, the System View will require
the code number to be entered when powering-up the System View using the HOME (Pow-
er) button.
NOTE: If you would like to set a security blind to keep others from viewing your on-screen
code entry, press HOME button momentary after viewing the keyless entry screen during
power up. This will change the code entries to (+) symbols and will allow you to enter your
keyless code without viewing the digits.
CREATING (FIRST TIME) KEYLESS CODE NUMBER
1. Power up the System View using the HOME button.
2. Open the System View directories to access the USER KEYLESS CODE menu.
3. Enter 4 zero's (0000) in the first menu box as follows:
a. Press A" to move the highlight box to each digit.
b. Press YB to select each digit.
c. After entering the 4 zero's (0000), Press SELECT to continue.
4. Select a permanent 4 digit key code number and enter that number in the second menu
box. Press SELECT key. This confirms the key code number.
TURNING OFF KEYLESS CODE NUMBER
Entering 4 zero's (0000) in the ENTER NEW KEY CODE box will turn off the Keyless Code
number screen.
Page 7-8
1
0 000
4
3
2
90-892133 JULY 2003