Asus M5A78L-M PLUS/ USB3 Manual page 14

Audio 2.1, 4.1, 5.1, or 7.1-channel configuration
Port
Light Blue (Rear panel)
Lime (Rear panel)
Pink (Rear panel)
Lime (Front panel)
To configure a 7.1-channel audio output:
7. USB 2.0 ports. These 4-pin Universal Serial Bus (USB) ports are for USB 2.0/1.1
devices.
8. USB 3.0 ports. These 9-pin Universal Serial Bus (USB) ports are for USB 3.0/2.0
devices.
•
•
•
•
9. DVI-D port. This port is for any DVI-D compatible device.
DVI-D can not be converted to output from RGB Signal to CRT and is not compatible with
DVI-I.
10. HDMI port. This port is for a High-Definition Multimedia Interface (HDMI) connector,
and is HDCP compliant allowing playback of HD DVD, Blu-Ray, and other protected
content.
11. USB 2.0 ports. These 4-pin Universal Serial Bus (USB) ports are for USB 2.0/1.1
devices.
1-6
Headset
2.1-channel
Line In Rear Speaker Out
Line Out Front Speaker Out
Mic In
-
Use a chassis with HD audio module in the front panel to support a 7.1-channel audio
output.
Due to USB 3.0 controller limitations, USB 3.0 devices can only be used under a
Windows OS environment and after USB 3.0 driver installation.
®
The plugged USB 3.0 device may run on xHCI or EHCI mode, depending on the
operating system's setting.
USB 3.0 devices can only be used for data storage.
We strongly recommend that you connect USB 3.0 devices to USB 3.0 ports for faster
and better performance from your USB 3.0 devices.
4.1-channel 5.1-channel
Rear Speaker Out
Front Speaker Out
Mic In Bass/Center
-
7.1-channel
Rear Speaker Out
Front Speaker Out
Bass/Center
- Side Speaker Out
Chapter 1: Product introduction