Table of Contents
Advertisement
Water Control Module
The water control module allows the hook up of a typical water feed to the inlet port.
When the solenoid is turned on via the connector from the control box water flows
through the inline pressure regulator through the solenoid valve into the adjustable visual
flow meter, and out though the outlet connector. The flow rate can be adjusted at the base
of the flow meter using the control knob.
When the unit is left standing for any length of time, or to be stored for freezing
temperatures, the water within the system must be drained to prevent damage due to
freezing. loosen the two drain cocks (7) and allow the water to drain out, leave loose unit
the unit is to be re-used. DO NOT OVER TIGHTEN when putting back into service.
4 GPM unit shown
1- Water flow meter 2 – Pressure regulator
5 – water INLET
6 – Water OUTLET
Page 16
3 – Solenoid valve
7 – Drain cocks
4 – Mounting
Advertisement
Table of Contents
