Advertisement
Auxiliary Connector J6
7. Mounting Orientation
The drive may be installed horizontally or Vertically. Provide adequate airflow to cool drive. Use 4
Mounting screws(6x32UNC). Maximum screw penetration 3.8mm(0.15 in) into drive.
8. For a 68-pin drive attach the power cable and ensure that one end of the SCSI cable
is connected to the host adapter. The cable should be terminated
into the server backplanes and requires no cables)
9. Ensure that all cables are connected and properly routed.
10. Turn on your computer.
•
If the system boots be sure the drive is recognized. If it is turn off the computer and replace the cover.
Proceed to install your operating system.
•
If your system does not boot up, turn off your computer and check all connections and settings. Turn
on and boot the system.
•
If the system fails to boot, turn off your system. Contact the Hitachi GST Technical Support Center for
assistance – www.hitachigst.com
Page 3
The 80-pin drive is plugged
. (
version 1.0
Advertisement
