Test Result Model No: SR 500SA Test Date: 20041004 Tester: mo guo zhu Test Item Test Conditions Spec Test Result Remark Power Source AC: 230V;50 Hz Idle Current AC 2 3 0 V No-Load 3 ± 0 . 5 mV across R26&R24 Power Rated Output.
Page 4
Test Result Model No:SR500SA Test Date: 20041004 Tester: mo guo zhu Test Item 1. Input 2. Signal/Noise 3. Distortion at 4. Distortion at 5. Frequency Sensitivity Rated Response Test Conditions FLAT Rated FLAT Rated FLAT Output FLAT Rated FLAT Output at...
Page 11
Instruments required: 1) Sinusoidal signal generator, 4) Variac 0-250 Vac, 5) Resistive load 4 Ω 8 00W, 2) Dual trace scope, with probe, 3) Digital multimeter, 6) Pink noise from the GM “AUDIO CD”. P.S: Isolate the oscilloscope from earth and adjust the two traces on center of screen in GND position.
TESTING PROCEDURE - Switch ON the LOW amplifier output to 4Ω load resistor and repeat the above booster check verifying more or less the same ± VCC1 conditions and verify that the signal must be symmetrical refer to GND, without detectable distortion and oscillation. Increase the VOLUME pot.
Page 18
M3*16 ND00537 ZC-grille-black SR 500A-SUB_V1.0 black MG00530 black screw-T headψ10 M3*30mm HG00129 speaker _bass 15吋 4Ω SR500SA(Z008288_LP385.75) ND00394 EV sponge-one side adhesive 2.0t*115*115 dark black V1.0 ND00395 EV sponge-one side adhesive 100*30*1 dark black_V1.0 ND00399 EV sponge-one side adhesive SR500A-SUB 100*30*1 dark black_V1.0 MG00338 black screw-T head ψ8...
Need help?
Do you have a question about the SR500SA and is the answer not in the manual?
Questions and answers