Hitachi Travelstar 7K100 Quick Installation Manual

Quick installation guide

Hitachi Travelstar
®
Travelstar
2.5 inch ATA/IDE & SATA hard disk drive
Models:
HTS721010G9AT00
HTS721080G9AT00
HTS721060G9AT00
HTS721010G9SA00
HTS721080G9SA00
HTS721060G9SA00
Handling precautions
Wear a grounded wrist strap while handling the drive
to prevent damage from Electrostatic Discharge
(ESD).
Set the drive down gently to prevent damage from
impact or vibration.
Do not open the ESD bag containing the drive until
needed.
Handle the drive carefully by the edges. Do not
touch the exposed printed circuit board or any
electronic components.
Do not press on the top or bottom of the drive.
Do not cover the drive's breather hole.
Quick installation
Installation of this Hitachi Travelstar drive in some note-
books may require use of unique hardware (such as
mounting trays, connecting cable, insulating material). If
you are uncertain if hardware is needed, consult your
notebook manufacturer as this operation may require a
qualified technician.
Back up all data before proceeding with installation.
1. Set the jumpers (ATA/IDE only)
Master drive. No jumper is required if the drive is
the only drive in a system or the Master drive in a
two-drive system.
Hitachi Global Storage Technologies
®
7K100 &
E7K100
HTE721010G9AT00
HTE721080G9AT00
HTE721060G9AT00
HTE721010G9SA00
HTE721080G9SA00
HTE721060G9SA00
Slave drive. If this is the Slave drive in a system,
place a jumper in setting A2. (See the A2 setting in
the illustration.)
Cable Select. Setting A3 in the illustration. Consult
the system manual to see if your computer supports
Cable Select
.
Jumper settings
A1. A2.
A1. Master A2. Slave
A4 & A5. Never attach a jumper in these positions!
2. Attach the drive
For assistance on the physical installation of the drive,
consult your system manual.
3. Configure the computer
1. Turn on the computer.
2. Enter Setup.
page 1
(ATA/IDE only)
A3. A4. A5.
Pin 1
A3. Cable Select
version 1.0