Download Print this page

Advertisement

Quick Links

Proudly Made in the U.S.A.
N53 W24700 South Corporate Circle
Sussex, WI 53089
U.S.A.
T T O O O O L L S S A A N N D D M M A A T T E E R R I I A A L L S S
R R E E Q Q U U I I R R E E D D
F F O O R R A A S S S S E E M M B B L L Y Y
• Two People
• Tape Measure
• Tape
• Shovel or Post-hole Digger and
Spade
• Concrete, 900 lb. (408 kg)
and Container to Mix
• Carpenter's Level
• Wrenches: (two each) 9/16",
1/2", and 3/4" or (two)
adjustable wrenches
• Step Ladder, 8 ft. (2.4 m)
To ensure prompt and correct handling of any problems, or to answer any questions,
please contact our Toll-Free Customer Service Number listed below.
S S e e r r v v i i c c e e w w i i l l l l b b e e q q u u i i c c k k e e r r i i f f y y o o u u h h a a v v e e y y o o u u r r M M o o d d e e l l N N u u m m b b e e r r a a n n d d
Toll-Free Customer Service Number for U.S: 1-888-713-5488
printed on recycled paper
U U l l t t r r a a A A d d j j u u s s t t 1 1 - - P P i i e e c c e e
®
P P o o l l e e & & G G r r o o u u n n d d S S l l e e e e v v e e
SAFETY INSTRUCTIONS
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN
SERIOUS INJURY, PROPERTY DAMAGE AND WILL VOID WARRANTY.
To ensure safety, do not attempt to assemble this system without following the
instructions carefully. Check entire box and inside all packing material for
parts. Before beginning assembly, read the instructions and identify parts.
Proper and complete assembly, use and supervision are essential for proper
operation and to reduce the risk of accident or injury. A high probability of
serious injury exists if this system is not installed, maintained, and operated
properly.
• This equipment is intended for home recreational use only and NOT
excessive competitive play.
• Read and understand the warning label enclosed with hardware. It is the
responsibility of the customer to mount this label. It should be affixed to
the pole, wall, or door near playing area, at a height between
4-6 feet (1.22-1.83 m) above ground level and in a location visible to all
players.
• During assembly, if using a ladder use extreme caution. Two people are
recommended for this operation.
• The life of your basketball pole depends on many conditions. The climate,
placement of the pole, the location of the pole, exposure to
corrosives such as pesticides, herbicides or salts are all important.
• Before digging, contact utility company to locate underground power
cables, gas and water lines. Make sure there are no overhead power lines
within 20 ft. (7 m) radius of pole location.
• Climate, corrosion and excessive use or misuse could result in pole
failure.
• Minimum operational height should be 6'6" (2 m) to the bottom of
backboard.
Most injuries are caused by misuse and/or
not following instructions.Use caution when using this unit.
H H a a v v e e Q Q u u e e s s t t i i o o n n s s . . . . . . C C a a l l l l U U s s ! !
a a s s s s e e m m b b l l y y i i n n s s t t r r u u c c t t i i o o n n s s r r e e a a d d y y w w h h e e n n c c a a l l l l i i n n g g . .
Your Best Shot!
1
10/01 P/N 211440A

Advertisement

loading
Need help?

Need help?

Do you have a question about the Ground Sleeve and is the answer not in the manual?

Questions and answers

Summary of Contents for SURE SHOT Ground Sleeve

  • Page 1 Your Best Shot! U U l l t t r r a a A A d d j j u u s s t t 1 1 - - P P i i e e c c e e ® P P o o l l e e &...
  • Page 2: Height Adjustment

    • Check system before each use for instability. • Never play on damaged equipment. • Keep pole top covered with cap at all times. SURE SHOT 1-888-713-5488 201245 2/99 HEIGHT ADJUSTMENT 1.TO RAISE BACKBOARD:...
  • Page 3 Your Best Shot! G G r r o o u u n n d d S S l l e e e e v v e e O O w w n n e e r r s s M M a a n n u u a a l l IMPORTANT! IF YOU ARE NOT INSTALLING A POLE SYSTEM INTO THE...
  • Page 4 I I M M P P O O R R T T A A N N T T ! ! ground sleeve (1). Clamp assembly MUST be positioned Assemble clamps (4) around pole as shown below. and ground sleeve (1) as shown. 10/01 P/N 211440A...
  • Page 5 1" (2.54 cm) Center and level ground sleeve assembly in hole. C C h h e e c c k k l l e e v v e e l l i i n n g g o o n n a a l l l l s s i i d d e e s s s s e e v v e e r r a a l l t t i i m m e e s s w w h h i i l l e e c c o o n n c c r r e e t t e e i i s s c c u u r r i i n n g g .
  • Page 6 WARNING Remove pole from ground sleeve. Insert pole cap onto end of pole. TWO PERSON MINIMUM Mix concrete (approximately 120 lbs. (54 REQUIRED FOR THIS PROCEDURE. NOT FOLLOWING kg)) and fill pole. RECOMMENDATION MAY RESULT IN BODILY INJURY. N N O O T T E E : : C C o o n n c c r r e e t t e e M M U U S S T T c c u u r r e e b b e e f f o o r r e e g g o o i i n n g g o o n n t t o o t t h h e e n n e e x x t t s s t t e e p p .
  • Page 7 Remove pole cap from pole section. Insert clamp assembly cap (6) onto lower end and position pole into secured ground sleeve (1). WARNING TWO PERSON MINIMUM REQUIRED FOR THIS PROCEDURE. NOT FOLLOWING RECOMMENDATION MAY RESULT IN BODILY INJURY. PLAYING SURFACE Secure clamps (4) around pole section as shown.
  • Page 8 Your Best Shot! U U l l t t r r a a A A d d j j u u s s t t O O w w n n e e r r s s M M a a n n u u a a l l I I M M P P O O R R T T A A N N T T ! ! IF STRUT HOLE SPACING ON ACRYLIC BACKBOARD IS 17.5”, PROCEED WITH STEPS 1 &...
  • Page 9 Assemble adjustment arm as shown. I I M M P P O O R R T T A A N N T T ! ! NOTE ORIENTATION OF BACK PLATE (2) Secure adjustment tube assembly (8) and backboard supports (9) in place as shown.
  • Page 10 Assemble adjustment arm as shown. I I M M P P O O R R T T A A N N T T ! ! NOTE ORIENTATION OF BACK PLATE (2) Secure adjustment tube assembly (8) and backboard supports (9) in place as shown. N N O O T T I I C C E E : : T T u u b b e e a a s s s s e e m m b b l l y y ( ( 8 8 ) ) n n e e e e d d s s w w e e i i g g h h t t o o f f f f u u l l l l y y a a s s s s e e m m b b l l e e d d...
  • Page 11 N N O O T T I I C C E E : : B B a a c c k k b b o o a a r r d d s s u u p p p p o o r r t t s s m m a a y y r r e e q q u u i i r r e e s s o o m m e e b b e e n n d d i i n n g g t t o o m m a a t t c c h h Secure adjustment assembly and rim to h h o o l l e e s s o o n n b b a a c c k k b b o o a a r r d d...
  • Page 12 Install net (16), as shown. I I M M P P O O R R T T A A N N T T ! ! M M A A K K E E WARNING S S U U R R E E N N E E T T I I S S H H E E L L D D B B Y Y A A L L L L T T H H R R E E E E H H O O O O K K S S O O N N T T H H E E N N E E T T C C L L I I P P .
  • Page 13 H H E E I I G G H H T T A A D D J J U U S S T T M M E E N N T T T T O O R R A A I I S S E E B B A A C C K K B B O O A A R R D D : : Slowly push up on the bottom of backboard at rim mounting area with broom handle or wooden dowel as...
  • Page 14 Qty. Part No. Description Item Qty. Part No. Description 206512 Clamp, V-shaped 206500 Ground Sleeve, Square 206252 Bolt, Hex Head, 3/8-16 x 1 Long 201124 Locknut, Hex Head, 3/8 - 16 206502 Clamp Assembly Cap 203232 Washer, Flat, 3/8 x 3/4 O.D.

This manual is also suitable for:

Ultra adjust