A-Tach Mounts ST-1 Instructions

A-Tach # 50148
Designed for: Jeep Wrangler JK 2006 – 2010
For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed BEFORE a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING: AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
mount will attach into the two seams illustrated
with the arrows in photo 1 and 2.
(3) Press the seam tool into the seam between the
dash top and the frame around the display/radio to
open the seam. See photo.
ST-1
Mobile Device Mounts
NOTICE: A-Tach Mounts will not be responsible for
any damage to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible for the use of the product and
to determine if you have the skill to attach the
product without causing damage to your vehicle or
the product.
Read all instructions and view the photos before
attaching this product.
(2) You will need to use the seam tool to open this
front seam up a little for the mount to insert into.
(4) Remove the covering from the tape on the
mount. Press the thin lower edge of the mount all
the way into the seam next to the seam tool until
the tape touches the dash top.
A-Tach