Denon AVR-X3200W Owner's Manual page 180

Contents Connections
TV Format
Set the video signal format to be output for the TV you are using.
o Format
NTSC
(Default):
PAL:
0 "Format" can also be set by the following procedure. However, the menu
screen is not displayed. Following the display content to make the setting.
1. Press and hold the main unit's ZONE2 SOURCE and STATUS at the same
time for at least 3 seconds.
"V.Format:<NTSC>" appears on the display.
2. Use the main unit's TUNER PRESET CH + or TUNER PRESET CH - and
set the video signal format.
3. Press the main unit's STATUS to complete the setting.
NOTE
0 When a format other than the video format of the connected TV is set, the
picture will not be displayed properly.
Front panel Display
Playback
Select NTSC output.
Select PAL output.
Rear panel
Settings
180
Remote
Tips Appendix
Index