Hitachi CP-X615 Network Manual page 7

2.2 Manual network connection setting (continued)
[About IP address]
■ Setting manually
The Network address portion included in the IP address set into your PC should
be common with projector's one. And the entire IP address in the PC should not
be overlapped with other equipments in the same network, including the projector.
For example
The projector's initial settings are as follows.
Therefore, specify PC's IP address as follows.
Select from 1 to 254 for "xxx" not duplicating with any other equipments.
In this case, projector has "192.168.1.10" IP address, specify from 1 to 254
except 10 for PC.
NOTE
• "0.0.0.0" cannot be set to the IP address.
• The projector's IP address can be changed by using the configuration utility
via a web browser. (11)
• If the projector and PC exist in the same network (i.e. network address is
common), default gateway can be blank.
• When the projector and PC exist in different networks, default gateway setting
is necessary. Contact the network administrator in detail.
■ Setting automatically
When DHCP server exists in network, it is possible to assign IP address to the
projector and PC automatically.
* DHCP is abbreviation for "Dynamic Host Configuration Protocol" and has the
function to provide necessary setting for network like IP address from server to
client. A server that has DHCP function is called DHCP server.
2. Equipment connection and network setting
IP address: 192.168.1.10
Subnet mask: 255.255.255.0
(Network address: 192.168.1 in this case)
IP address: 192.168.1.xxx (xxx shows decimal number.)
Subnet mask: 255.255.255.0
(Network address: 192.168.1 in this case)
7