Hitachi CP-X2510N User's Manual And Network Manual page 39

3.4 Event Scheduling (continued)
Date/Time Settings (24)
The Date/Time setting can be adjusted via a web browser.
Example: If the IP address of the projector is set to 192.168.1.10:
1) Enter "http://192.168.1.10/" into the address bar of the web browser. Enter the
Administrator ID and Password and click [Logon].
2) Click [Date/Time Settings] on the main menu and configure each item. Refer
to the item 3.1.8 Data/Time Settings for further information.
3) Click [Apply] button to save the settings.
NOTE
• A Network Restart is required after the Daylight Savings Time or
SNTP configuration settings have been changed.
• The battery for the built in clock may be dead if the clock loses time even
when the date and time have been set correctly. Replace the battery by
following "Replacing the internal clock battery" section of the User's
Manual (concise).
• The internal clock's time may not remain accurate. Using SNTP is
recommended to maintain accurate time.
3. Network Functions
39