Denon AVR-X2500H Service Manual page 137

3-5. TUNER STEP mode (E2 / E3 only)
3-5.1. Actions
This is a special mode for enabling reception STEP of the ANALOG TUNER to be changed.
3-5.2. Starting up
AVR-X2500H
• While holding down buttons "ZONE2 SOURCE", "DIMMER" and "STATUS" simultaneously, press the
power button to turn on the power.
AVR-S940H
• While holding down buttons "TUNER PRESET CH +", "TUNE -" and "TUNE +" simultaneously, press
the power button to turn on the power.
Select the "5. TUNER FRQ SET" using the "TUNER PRESET CH +/-" button, then press the "STATUS"
button then to confirm.
3-5.3. Displays
Start up this unit in TUNER STEP mode, select the desired option using the "TUNER PRESET CH +/-"
button, then enter using the "STATUS" button.
The following information is displayed in the following order.
(1) AM9 kHz / FM50 kHz is selected
< AM9/FM50 >
"TUNER PRESET CH +" "TUNER PRESET CH -"
(2) AM10 kHz / FM200 kHz is selected
< AM10/FM200 >
"STATUS"
(3) Press the power button to turn off the power.
(4) Press the power button to turn on the power.
3-6. Remote ID Setup Mode
3-6.1. Actions
This function allows only the desired AV receiver to be operated if multiple DENON AV receivers are
used in the same room.
3-6.2. Starting up
AVR-X2500H
• While holding down buttons "ZONE2 SOURCE", "DIMMER" and "STATUS" simultaneously, press the
power button to turn on the power.
AVR-S940H
• While holding down buttons "TUNER PRESET CH +", "TUNE -" and "TUNE +" simultaneously, press
the power button to turn on the power.
Select the "6. REMOTE ID" using the "TUNER PRESET CH +/-" button, then press the "STATUS"
button then to confirm.
3-6.3. Operations
(1) When Remote ID Setup mode is activated, the following message is displayed.
REMOTE ID ?
(2) Press the desired "QUICK SELECT 1 - 4" button.
Button
QUICK SELECT 1
REMOTE ID 1
QUICK SELECT 2
REMOTE ID 2
QUICK SELECT 3
REMOTE ID 3
QUICK SELECT 4
REMOTE ID 4
(3) Press the power button to turn off the power.
(4) Press the power button to turn on the power.
b Only "QUICK SELECT 1 - 4" and the POWER button on the unit can be used in Remote ID Setup
Mode.
b The remote ID of the remote control supplied with this unit cannot be changed.
NOTE :
If the ID of the unit and remote control do not match, "AVAMP z " appears on the display of the unit
when the remote control is used
( z : own remote control ID).
137
Display