Table of Contents
Advertisement
Available languages
Available languages
4.3
Switching on the machine
INFORMATION
The machine cannot be started, if the drill chuck guard is not closed and the locking pin
of integrated drill drift is in drifting position.
Switch on the master switch.
Select the transmission stage and speed stage of drive motor.
Set the height of drill chuck guard and close the drill chuck guard.
Make sure that the drill drift locking pin is fully inserted.
Actuate the push button "ON". If necessary, switch the direction of rotation to clockwise
rotation.
For DH35G machines with integrated control:
In the event of an overload, the control unit protects the drive motor. The overload LED
on the integrated control unit in the control cabinet next to the red reset button lights up
yellow.
Press the red reset button to reset the overload and check the cause of the overload.
4.4
Switching off the machine
CAUTION!
Only press the emergency-stop button in a genuine emergency. You should not use the
emergency stop button to stop the machine during normal operation.
Actuate the push button "OFF".
For a long-term standstill of the machine switch it off at the master switch.
4.4.1
Gear selector switch
The speed is selected by means of the gear selector switches.
Only switch during standstill of drilling spindle.
Gear selector switch
INFORMATION
Observe the speed table on the drilling head when selecting the range of speed.
Img.4-2:
~50Hz spindle speeds
EN
DH35G
80
Translation of original instruction
Operation
Version 1.0.4 - 2022-02-15
Advertisement
Table of Contents
