Table of Contents
Advertisement
Fault
"E:30 / -80"
"E:36 / -25 / -26"
"E:38 / -25 / -26"
"E:60 / -2B"
"E:35 / -10"
Cause and troubleshooting
The pump cap is not fully screwed in.
Ensure that the pump cap is screwed in all the way
▶
into the appliance. The handle on the pump cap
must be in a vertical position.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 38
▶
Drain pump is blocked.
→ "Cleaning the drum", Page 37
▶
if the fault is displayed again,
→ "Cleaning the drain pump", Page 38
▶
Inlet opening of the rubber gasket is blocked.
→ "Cleaning the intake opening in the rubber gas-
▶
ket", Page 41
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
The water pressure is low.
No remedial action possible.
The filter in the water inflow is blocked.
Clean the water inflow filter.
▶
The tap is turned off.
Turn on the tap.
▶
The water inlet hose is kinked or jammed.
Ensure that the water inlet hose is not kinked or
▶
jammed.
Water level measurement system is defective.
Call the after-sales service.
▶
→ "Customer Service", Page 52
There is water in the base trough.
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 52
The appliance is leaking.
Turn off the water tap.
▶
Troubleshooting en
43
Advertisement
Table of Contents
