Unpacking; Ac Power Requirements; Mechanical Installation - Ashly DPX-100 Operating Manual

Graphic equalizer compressor/limiter

Hide thumbs Also See for DPX-100:

Table of Contents

Operating Manual - DPX-100 Graphic Equalizer - Compressor/Limiter

As a part of our system of quality control, every Ashly product is carefully inspected

before leaving the factory to ensure flawless appearance. After unpacking, please inspect

for any physical damage. Save the shipping carton and all packing materials, as they were

care-fully designed to reduce to minimum the possibility of transportation damage should

the unit again require packing and shipping. In the event that damage has occurred,

immediately notify your dealer so that a written claim to cover the damages can be

initiated.

The right to any claim against a public carrier can be forfeited if the carrier is not

notified promptly and if the shipping carton and packing materials are not available for

inspection by the carrier. Save all packing materials until the claim has been settled.

A standard IEC-320 AC inlet is provided on the rear panel to accept the detachable

power cord shipped with the unit. Units distributed within the United States are pre-

selected for 120 VAC, 60 Hz and should be plugged into a standard NEMA 5-15 3-wire

grounded AC receptacle. Most units distributed outside the US are pre-selected and

labeled for 240 VAC, 50-60 Hz and are shipped with the appropriate power cord.

The DPX-100 will perform normally from 95 to 125 volts AC. An internal line fuse is

used. In the event of fuse failure, refer to a qualified service technician for servicing. Power

consumption is less than 20 watts.

The DPX-100 mounts in a standard 19 inch equipment rack. The mounting screw

threads vary with different rack manufactures and you should refer to your rack

instructions for proper hardware. An oval head or flat head screw with a plastic

countersink washer is preferred to protect the finish of the DPX-100 under the screw.

This unit is housed in a rugged steel case and will tolerate moderate abuse.

However, for road systems which may be dropped or otherwise subjected to extreme

forces, we recommend some rear support for the chassis to prevent bending the front

panel the front panel when these forces occur.

For installations where it is desirable to protect the front panel controls from

tampering or accidental misadjustment, use the Ashly security cover. Installation is simple

2. UNPACKING

Table of Contents