Advertisement
To realize quieter operation, a bottom cover is supplied with the unit (only applies
to some of the Hisense washers). After installing the cover at the bottom of the
washer, the noise level will be greatly reduced. Please ask for advice from
specialists before installing the cover, nevertheless, the machine can be used
without the bottom cover.
Noise-Reduction Bottom Plate Installation Instructions
8
A:
Stick acoustic wool to the side of bottom cover plate
with the letter of "PUMP".
Tilt the washer by 30°-40°, when installing the bottom
cover, please face the side with sound insulation
upwards and attach 'PUMP' at the corner of the cover
to the position of the pump in the washer.
B:
Before installing the noise-reduction bottom
plate, align and paste the acoustic absorption
wool with and along the right-angle impression
on bottom plate (this procedure is unnecessary
for some of the models without acoustic
absorption wool).
Incline the machine to an angle of 40° and let
the side with right-angle notch face towards
front of the washing machine, as shown in the
figure. Insert the side with oblique-angle notch
between two foot screws at back of the
Pump
washing machine completely in place. Then,
install the bottom plate and ensure that it
contacts with bottom of the washing machine
closely.
INSTALL BOTTOM COVER
PUMP
Remove surface paper on
double sided tape at four sides
of the bottom plate.
Double sided tape
Press the double sided tape
on four sides manually to
secure the noise-reduction
palte to the machine body
firmly.
PUMP
Advertisement
