Lay-Z-Spa Grenada Airjet Manual page 31

• Keep suitable air treatment in the spa chamber (ventilation and
dehumidification) regularly to preserve the bathers' safety and
comfort .
• Do not to install the spa on carpet or other floor materials (e.g.
untreated cork, timber or other porous materials) that promote
or harbour moisture and bacteria, or that could be affected by
water treatment chemicals used in the spa.
• Empty the spa before remove it from the chamber or building.
2. Outdoor Installation:
• During filling, draining or when in use, water may flow out of the
spa. Therefore the Lay-Z-Spa should be installed near a floor
drain.
• Do not leave the spa's surface exposed to direct sunlight for
long periods of time.
• Consult your local professional installers for environmental
conditions, such as ground water and risk of frost.
• Recommended to protecting the spa from direct sunlight
exposure by a cover when not in use.
WARNING: Before inserting plug into a power outlet, make sure
the current rate of the power outlet is suitable for the pump.
WARNING: Using an extension lead or multi plug adaptor with
the spa heater can cause the plug to overheat, causing damage
to the equipment and surrounding items. The spa is a class I
electrical appliance and must be connected directly to a
grounded socket. It is recommended to only use a socket which
is resistant to humidity and capable of high power loading.
Regularly check the plug and socket for signs of damage before
using the spa – do not use the spa if the plug or socket is
damaged. If you are unsure about the quality of the electrical
supply, please consult a qualified electrician before use.
WARNING: The PRCD plug must be tested before each use to
avoid risk of electric shock.
WARNING: Do not use the pump if this test fails. For assistance,
please visit the support section on our website,
www.bestwaycorp.com.
PRCD WARNING
11