Plug Configurations - Hatco TOAST KING TK-100 Installation & Operating Manual

PLUG CONFIGURATIONS

Units are supplied from the factory with an electrical
cord and plug installed on the back of the unit. See
ELECTRICAL RATING CHART and Figure 3. The cir-
cuit must be sized depending on the model amp rating.
NOTE: See the specification plate located on the front
of the unit at the control panel for proper electrical
requirements.
WARNING
!
Plug toaster into an electrical outlet of the correct
voltage, size and plug configuration. If the plug and
receptacle do not match, contact a qualified electri-
cian to determine the proper voltage and size and
install the proper electrical outlet.
If local codes require Greenfield or conduit hook-up,
consult a licensed electrical contractor to perform supply
wire connection. Access to the unit wiring is through the
rear lower access panel.
To connect supply wires to the toaster:
1. Remove the screws securing the side panels and
remove them.
NEMA 5-30P
NEMA 6-30P
CEE 7/7 Schuko
Figure 3. Plug Configurations
2. Remove the screws securing the rear lower access
panel, and remove the panel.
3. Insert the Greenfield or conduit through the opening
in the rear access panel and attach to the power sup-
ply bracket. Connect the wires.
4. Attach ground wire to power supply bracket at
threaded hole marked "G".
5. Reinstall access panel and side panels.
5
SPECIFICATIONS
NEMA 6-20P
BS 1363
Form No. TR/TKM-0400