Watching - Panasonic LX800H Series Operating Instructions Manual

Select the language
Register (pair) the Bluetooth
Point the remote control at the TV's remote control
≥
signal receiver, then press and hold the volume down
button and the Google Assistant (voice control) button
simultaneously for 3 seconds.
Set up your Wi-Fi network and Google account
If you are using an Android phone for setup, select
≥
[Continue]. You can then easily transfer your Android
phone's Wi-Fi network and Google account to your
TV.
If you are not using an Android phone for setup, select
≥
[Skip], then complete settings on the setup screen
which appears next.
Enter the PIN number for parental controls
Run a channel scan
Select [Home]
Select [Home] for use in a home viewing environment.
[Shop] is for shop display.
≥
To change the viewing environment later on, the set
≥
will need to have all settings initialised by accessing
[Reset].
Initial Setup is now complete and the
TV is ready for viewing.
If tuning has failed check the RF cable, and the network
connection, and then follow the on-screen instructions.
Note
≥ The TV goes into Standby mode when no signal is
received and no operation is performed for 10 minutes
if [No Signal Power Off] in the Power menu is set to
[10 Minutes] (factory setting).
≥ To retune all channels
[Channel Scan] (Settings > Channel > Channels)
To initialise all settings
≥
[Reset] (Settings > Device Preferences > About)
® remote control
Watching TV
1
Turn power on
(TV)
or
(Remote Control)
Mains power On / Off switch should be on.
≥
(p. 22)
2
Select TV
TV
3
Select a channel
up
down
or
To select a channel position with 2 or more-digit, e.g.
≥
399
23
English