Larson Electronics LEDB-6R-M-WR-WF-SP3100 Instruction Manual

Replacement Remote for LEDB-6R-M-WR Fixtures
Thank you for your purchase of the Larson Electronics LEDB-6R-M-WR-WF-SP3100.
WARNING:
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CRITICAL SAFETY INSTRUCTIONS:
INSTALLATION SHOULD ONLY BE CONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY
•
RELEVANT LOCAL BUILDING CODES.
RISK OF FIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF FIXTURE'S ELECTRICAL
•
SYSTEMS. IF NOT QUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.
• BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.
• MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE FIXTURE'S RATED VOLTAGE.
• TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP
OBJECTS. SUITABLE FOR DAMP LOCATIONS.
IMPORTANT
READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE.
ACCORDANCE WITH
GROUNDING IS REQUIRED FOR SAFETY.
WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN
THIS PRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION
SHEET, CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.
WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THE
INSTALLATION OR PERFORMING ANY MAINTENANCE.
RISK OF FIRE/ELECTRIC SHOCK –
RISK OF PERSONAL INJURY –
RISK OF BURN –
ALLOW FIXTURE TO COOL BEFORE SERVICING.
The LEDB-6R-M-WR-WF-SP3100 replacement remote can be used to replace lost, damaged, broken, or otherwise
malfunctioning remote controls for existing LEDB-6R-M-WR fixtures.
REMOTE
• Remove white cover from receiver
• Press and hold the white button on receiver
• Light will begin to flash, it will flash once and pause, then flash twice and pause, then three times and pause, etc...
• The number of flashes indicates the modes. Two flashes is momentary (on when holding the button off when it's let
go) and three flashes is maintained ( on button press will turn it on, another button press will turn it off). All the other
modes are for different remotes so you only want 2 or 3 flashes. Once it's flashes the desired amount of times let the
button go and press it again. The light should stay lit now.
• Press the button on the remote, the light in the receiver should flash. Do this three times to pair the remote. The light
should turn off and the remote should now be paired.
Larson Electronics, LLC
Instruction Manual
THE LEDB-6R-M-WR-WF-SP3100
NATIONAL ELECTRICAL CODE AND ALL APPLICABLE LOCAL CODES. PROPER
DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.
FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.
Phone: (800) 369-6671
MUST
Fax: (903) 498-3364
LEDB-6R-M-WR-WF-SP3100
BE WIRED IN
www.larsonelectronics.com
1 of 2