Larson Electronics GL-30200 Instruction Manual

GL-30200 Dash Mount Remote for Golight Stryker and Radioray Wireless
Thank you for your purchase of the Larson Electronics GL-30200.
WARNING:
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CRITICAL SAFETY INSTRUCTIONS:
INSTALLATION SHOULD ONLY BE CONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY
•
RELEVANT LOCAL BUILDING CODES.
• RISK OF FIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF FIXTURE'S ELECTRICAL
SYSTEMS. IF NOT QUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.
• BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.
• MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE FIXTURE'S RATED VOLTAGE.
• TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP
OBJECTS. SUITABLE FOR DAMP LOCATIONS.
IMPORTANT
READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE. THE GL-30200 MUST BE WIRED IN ACCORDANCE WITH NATIONAL ELECTRICAL CODE AND ALL
APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.
WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THIS
PRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION SHEET,
CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.
WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THE
INSTALLATION OR PERFORMING ANY MAINTENANCE.
RISK OF FIRE/ELECTRIC SHOCK –
RISK OF PERSONAL INJURY –
RISK OF BURN –
ALLOW FIXTURE TO COOL BEFORE SERVICING.
The GL-30200 is the dash mounted remote control for the Golight Stryker wireless remote control spotlights and Golight Radioray
wireless remote control searchlights. While specified for the Golight Stryker series (GL-3XXX), this remote works with the Golight
Radioray series, if those wireless remote control spotlights (GL-7XXX or GL-2XXX) were purchased within the last 3 years.
Golight remote control spotlights are based on radio waves, not infrared (like your garage remote. As such, these remote controls are
effective to 150 feet.
This remote control is considered dash mounted because once the rubber cover is removed, the unit can be attached to any
mounting surface by fastening 4 screws through the holes shown below. The rubber cover is replaced, providing weather resistant
protection to the internal electronics.
Powered by 2 MN-21 batteries, which are included and last approximately 1 year, the unit has a series of dip switches. The dip
switches enable the user to select one of 65,000 channels to communicate with a specific remote control spotlight.
This dash mounted remote control features an on/off button, a fast/slow selector and 4 directional buttons. The motorized remote
control spotlight will move in a direction as long as the button is depressed. Once released, the remote control spotlight will hold that
position. These dash mount wireless remotes measure 4.38 inches long by 2.65 inches wide by 1/2 inch thick.
Low Voltage DC
Connect power to power supply outputting low voltage between 9-42 Volts DC.
This variable voltage allows greater versatility without affecting light output. Ensure
deutsch connectors are properly connected (If applicable)
Larson Electronics, LLC
Remote Control Spotlight
Instruction Manual
DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.
FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.
Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com
GL-30200
1 of 3